Alpha Model AM02-0039 · Build by mG Car Scale Model Works

1/24 Scale Full Detail Kit AUDI RS6 Avant • AM02-0039

Background Information

As with the previous generation, the new RS6 is powered by a 4.0-litre twin-turbo TFSI petrol engine, now boosted by a 48V belt alternator/starter mild-hybrid system, which can recover up to 16 bhp (12 kW). The acceleration to 100 km/h takes 3.6 seconds and 200 km/h in 12 seconds. As standard, top speed is limited to 250 km/h, with a further two levels courtesy of optional packs — the Dynamic package allows 280 km/h, while the Dynamic package plus grants even more headroom for a maximum of 305 km/h.

The Quattro system has power distribution with 40% for front and 60% for rear. The system can adjust the power distribution up to 70% for front and to 85% for the rear if needed. The adaptive suspension system is 20 mm lower than standard A6 and can lower the vehicle further 10 mm during high-speed driving or can raise the ride 20 mm at low speed. The Drive Select function gains configurable RS1 and RS2 modes, which are activated by an 'RS mode' button positioned on the steering wheel.

As well as adjusting the engine and handling responses, they also enable bespoke information on the Virtual Cockpit system.

Technical Specs

1/24 Scale Full Detail Kit AUDI RS6 Avant • AM02-0039

Unboxing

The Porsche is done, so it is time to present and unbox the next project. Ladies and gentlemen here is the AUDI RS6 Avant.

As usual the kit is made of resin and metal PE parts. The quality of the casts is great, without any flaws. The model is nicely divided to make detailing work a lot easier. The only flaw of the kit in my opinion are the wheels. They are nicely detailed and cast but they look a bit small. The PE parts represent all the details needed to build an amazing model. There are also some decals to depict some carbon fibre details on the outside.

And just to make it a bit more interesting the Hobby Design 56 Nord roof top box will be added.

Special Addition: Geronimoworks Wheels

I have showed you my next project and hinted that there will be something special coming to the project. So here it is.

Since I have already chosen to add the roof top box to the car I have also decided to change the wheels. And what better way to do this than to contact Geronimoworks for some advice and help at choosing the right wheel size for the RS6.

Somewhere on the internet I have found a picture of a RS6 with the HRE S111 and since I liked the design a lot I opted for the same design from Geronimoworks.

To make sure the size will be perfect for the RS6, Geronimoworks suggested me to use 22" wheels with Dunlop tires. These are also my first multipiece wheels, so this means that barrels and centers are divided.

As it is usual with Geronimoworks the print quality is amazing, without any flaws and with amazing details. Also included are decals, two different sets of lug nut adapters and a set of valves.

Next: Preparing Resin Parts